LABVIEW EUROTHERM DRIVER DOWNLOAD

Sounds like we have quite a few different things going on here, so lets backtrack a bit and see where were getting the communication issues. Thanks for the reply The loopback works well and the LabVIEW driver I am using is directly downloaded from NI website et24xx so it can be assumed that the problem is not on the code? Message 5 of 6. Message 2 of 6. Another solution we also successfully used was to place an Eurotherm KD converter between the RS interface on the computer and the RS interface in the Eurotherm controller.

Uploader: Vilmaran
Date Added: 7 September 2010
File Size: 61.68 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 36847
Price: Free* [*Free Regsitration Required]

I hope this information will help you make your system work. With this configuration, I made it work. Do a search on RS bias resistor eurothedm the NI sites and you should get a document that explains about this.

Eurotherm et3500 Controller

The REM should flash when there is a connection however I cant get it flash so I assume the problem is in connection. I also spent quite a bit of time for setting up Eurotherm RS Eurothefm.

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Unless your interface card has these resistors built in, it is likely the problem why you can’t get this work. Another solution we also successfully used was to place an Eurotherm KD converter between the Eurothdrm interface on the computer and the RS interface in the Eurotherm controller.

  BROADCOM BMC4401 32BIT PCI 10/100 BASET LAN DRIVER

LabVIEW Drivers

Also, the et24xx driver maybe shouldn’t be assumed to work. Message 5 of 6. Or should I buy the serial protect from NI?

We primarily host it for convenience. What did work is to replace the RS interface in the controller with a RS module and kabview it to an RS port on the compactFieldpoint.

This was not possible to get working although I didn’t have a chance to go very deep into debugging with this. Instructions for that are here: Message 6 of 6.

Rolf Kalbermatter Averna BV.

Eurotherm et24xx Controller

On software configuration, here is the list. Can anyone give me a hand? Most Active Software Boards: Some of the NI plugin boards lbview have programmable bias resistors that can even be switched on and off through a VISA attribute node if I’m not mistaken.

I found that terminal registor cause significant voltage drop, so I do not use any termial registor. Message 4 of 6. Now I have a strong suspicion that the Eurotherm driver you downloaded was actually developed and tested with a controller with RS interface. Also, I am thinking if the issue is due to the incorrect serial port I am using. The unit I got from the client to do some testing in our office appeared to be defect, and testing in the factory installation is a hassle.

  F5D8010 XP DRIVER

Message 1 of 6. I encounter a problem with my project. Thanks for the reply The loopback works well and the LabVIEW driver I am using is directly eurothrm from NI website et24xx so it can be assumed that the problem is not on the code? Sounds like we have quite a few different things going on here, so lets backtrack a bit and see where were getting the communication issues.

Applications Engineering National Instruments. The Eurotherm controllers can be delivered with either RS or RS interface it’s a module that can be replaced inside the controller. Also, just wonna make sure that whether the serial port I am using is compatible.

Communication with Eurotherm via LabVIEW – Discussion Forums – National Instruments

Message 3 of 6. Message 2 of 6.

Is it really necessary for me to use the serial port from NI instead of using random brand serial port? However time and other constraints did not allow us to debug that deep enough to make it work as a full RS connection.